Abstract This paper presents preliminary data from an ongoing study on the radar cross section (RCS) of targets with simple and complex surface geometries (a flat square plate, a 90° dihedral corner reflector and a retired air-to-air missile). Measurements and computer simulations of these metallic targets were carried out at 10 GHz and also when the surfaces of the targets were completely coated with a radar absorbing material (RAM), consisting of flexible sheets of carbonyl iron dispersed in a silicone rubber matrix. Experimental measurements were obtained in an outdoor facility, and computer simulations were performed using a commercial software package. The main objective of this study was to compare results in order to highlight some of the issues related to the determination of the RCS of an actual target. Additionally, a Brazilian research institute has demonstrated the capability to produce and characterize materials related to the main aspects of RCS research, namely, measurement, simulation, and production of RAM. This paper introduces the reader to the research being carried out in this area at the Materials Division in the Instituto de Aeronáutica e Espaço.

The aim of this study was to produce sheets of microwave absorbing materials using conductive polyaniline dispersed in a silicone rubber matrix and to characterize the electromagnetic properties (absorption, transmission and reflection of electromagnetic energy; and electric permittivity and magnetic permeability) of these sheets in the X-band (8 - 12 GHz). Two sheets were produced: one 2.80 mm thick and the other 4.39 mm thick. The thinner sheet absorbed incident microwave energy more efficiently, attenuating up to 88% of the incident electromagnetic energy. Also, calculations were performed in order to determine the electromagnetic parameters that optimize the absorbent properties of these sheets. These calculations showed that these materials can be combined and altered to produce absorbing materials with a wide range of absorbing characteristics.

The use of polyamic acid (PAA) precursor as interphase in polymer composites is one of the many applications of polyimides (PIs). In this work, composites based on poly(ether-ether-ketone) (PEEK) and carbon fibers were prepared using two manufacturing techniques for thermoplastic composites: hot compression molding, and aqueous polymeric suspension prepregging using PIs as interphase. Two PAAs were synthesized and used as interphases: 3,3'-4,4'-benzophenonetetracarboxylic dianhydride/oxydianiline (BTDA/ODA) and pyromellitic dianhydride/oxydianiline (PMDA/ODA). The PAA/PI systems were analyzed by differential scanning calorimetry (DSC), thermogravimetry (TGA), Fourier transform infrared spectroscopy (FTIR) and nuclear magnetic resonance (NMR). Results from these analyses confirmed the synthesis of these compounds. Aqueous polymeric suspension prepregging was more efficient than hot compression molding when the PMDA/ODA PAA/PI interphase was used; also, the interlaminar shear strength of composites produced using this technique was 14.5% higher than the one produced using hot compression molding.